How to Adjust uPVC Window Hinges and Handles

uPVC windows are designed to be adjustable, so a stiff, dropped or slightly draughty window can often be put right with a screwdriver and a few minutes — no new window needed. Here’s how to do it safely and know when to stop.

Before you start

Work gently, make small adjustments and test after each one. Over-tightening can strain the hardware. You’ll usually need a Torx (star) or Allen key and sometimes a Phillips screwdriver. If the window is under guarantee, check whether adjusting it yourself affects your cover, and keep a note of which way you turned each screw so you can reverse it if needed.

Fixing a dropped or rubbing sash

uPVC friction hinges (the metal stays along the top and bottom of an opening casement) often have small adjustment screws. Adjusting these raises, lowers or shifts the sash within the frame so it sits square and stops catching. Open the window, locate the screws on the hinge arms, and make small turns, testing as you go. A sash that catches on one corner usually just needs a slight lift on that side.

Curing a draught (compression)

Many uPVC windows have cam adjusters on the locking mechanism along the edge of the sash — small mushroom-shaped cams that engage the keeps on the frame. Turning these slightly changes how firmly the sash is pulled against the seal. Tightening compression a little can cure a minor draught; don’t overdo it, or the handle becomes hard to operate. This is the same principle used to fix a stiff-to-lock door.

Sorting a loose or stiff handle

  • Loose handle: pop off the screw cover, tighten the fixing screws.
  • Stiff handle: lubricate the locking mechanism with silicone or PTFE spray, operating the handle to work it in. Regular lubrication is part of good maintenance.

Keep the mechanism clean

Grit in the hinges and locking channel causes a lot of stiffness. Wiping the seals and channels and keeping the drainage holes clear prevents problems before they start — and a clean, lubricated mechanism adjusts far more easily.

When to stop and call a pro

If a sash won’t sit square however you adjust it, a hinge is damaged, or the locking mechanism has failed, it’s time for a glazier. These parts are standard and replaceable, so repair is usually cheaper than a new window — our guide on repair vs replace helps you judge when a window is genuinely past adjustment.

Understanding the three directions of adjustment

Most uPVC friction hinges allow adjustment in up to three ways: height (raising or lowering the sash), lateral (shifting it left or right so it sits central in the frame) and compression (how tightly it pulls against the seal, set by the cam locks). Knowing which you need saves fiddling: a sash catching at the bottom corner needs a height tweak; one rubbing on one side needs lateral; a slight draught needs a touch more compression. Make one change at a time and test, so you can tell what each adjustment did.

Safety and knowing your limits

Adjusting hinges and handles is well within most people’s DIY ability, but work safely: don’t lean out of upper-floor windows, support the sash so it can’t drop, and don’t force anything that resists. If a sash won’t sit square however you adjust it, a hinge is bent or a mechanism has failed, and that’s a job for a glazier with the right replacement parts. These parts are standard and cheap, so a professional repair is still far less than a new window — don’t persevere to the point of damaging the frame.

Related guides

Ready to get quotes? Find trusted local double glazing installers on our directory and compare them side by side — it’s free and there’s no obligation.

Sources & further reading

Get your business in front of homeowners

Add your double glazing business to the UK’s biggest fenestration directory — homeowners near you are searching for quotes right now.

Add your business
AdAdvertisement
Get free quotes